Is Your Furnace Not Working?

A natural gas heating system is quite easy to operate and maintain. But unfortunately, because of prolonged use or other circumstances, your natural gas furnace might begin to malfunction-which is not something that you want.

The Most Common Causes

Before you start to inspect your unit, we strongly advise you to take these preliminary steps to eliminate possible unseen problems.

  1. Check out if your furnace is receiving power. You should look in detail at the state of the circuits at the entrance in the unit as well as around the unit.
  2. Inspect if the unit has a RESET button, which should be present near the motor housing. Turn off your natural gas furnace and wait about 30 minutes for it to cool down, then press the button. If the furnace does not start, wait another 30 minutes and press it again. Repeat the procedure for the third time before you renounce on the idea.
  3. Inspect your furnace for a second power switch and make sure that it is turned on.
  4. Inspect your thermostat to make sure it has been properly set. We also recommend that you increase the setting by 5 degrees as many modern thermostats have a 2-3-degree window besides the temperature set.
  5. Make sure that your gas supply is turned on and the pilot light is functioning properly.

The Three Main Causes For Your Natural Gas Furnace Not Working Properly

If your natural gas furnace is still not working properly after performing the above tests, then the problem is most likely caused by the malfunction of one of the following three components: the heat source, the thermostat, or the distribution system.

If your natural gas furnace is not working, then the problem is most likely caused by the source. Your furnace might not be receiving the natural gas which is its fuel source, so it is not igniting.

If your natural gas furnace does turn on, but the warmth is not reaching the rooms of your house, then the problem is probably related to the furnace’s distribution system.

If the natural gas furnace has random problems in turning on or it turns on and off repeatedly on a functioning cycle, then the problem might be caused by a faulty thermostat.

Each of these three main categories require extensive knowledge, and we would hate to see anyone come into an unsafe situation while trying to repair a furnace themselves. Climate Control Experts is always happy to lend a helping hand.

Some Safety Advice

Before you start working on your natural gas furnace we recommend that you take note of the following:

  • Make sure that your furnace is completely powered off by removing the main fuse. If the fuse of your house blows off when you power your furnace, then this means that it’s an electrical problem and you need to consult a specialized electrician.
  • Make sure that there is no smell of gas in the house as this might indicate a gas leak. If you sense the smell of gas, do not try to shut down the gas or power on any electrical device. Open the doors and windows, get outside of the house and call the gas company to report a leak. To not reenter the house.

Contact Climate Control Experts Today!

    • Please enter your name.
    • This isn't a valid phone number.
    • Please enter your email address.
      This isn't a valid email address.
    • Please make a selection.
    • Please enter a message.
Put Us On Your Side